Treadcote Paint for Treadmaster

Availability: For ONLINE ORDERS ONLY
For ONLINE ORDERS ONLY. Items will be dispatched within 2-7 Days.
0
Dublin Stock
Stock locations #
Dublin Stock 0
Barcelona Warehouse

0

Holland Warehouse

0

0.00
(0 recensioni) Write a review
MTMS000007
€12125 (Inclusa tassa)
+
Aggiungi al carrello
Oppure utilizza
  • Brand
  • Delivery Info
  • RETURNS POLICY
  • REVIEWS

Treadcote (for Original only) -  (1ltr bottle, coverage 75m2)
TREADCOTE is designed to rejuvenate the appearance of heavily weathered or stained TREADMASTER Original. This paint is easy to apply, with full surface preparation and application details shown on the can.

INSTRUCTIONS FOR USE
Surface Preparation

The Treadmaster Original must be completely clean, dry and free of any oil, grease or other contamination.

The surface should be prepared by gentle but thorough scrubbing with Treadmaster Cleaner (available direct from Tiflex) taking care to clean well into the surface profile, but avoiding damaging the pattern. Finally the Treadmaster should be thoroughly rinsed and allowed to dry.

Conditions

Ensure good ventilation throughout the operation.

Painting should only be undertaken in dry conditions at temperatures between 10°c and 25°c.

Application

The deck should be masked off around the sheet to prevent splashing.

Any splashes on surrounding surfaces should be wiped up immediately.

The Treadcote will settle during storage. Before use the container should be swirled gently from end to end for 5 minutes to ensure even dispersion of pigments. Do not shake vigorously. When ready for use the Treadcote should appear evenly coloured and have a thin creamy consistency.

Agitate occasionally during use.

For application to Treadmaster DP (diamond pattern) brush carefully along the grooves in both directions, without allowing the Treadcote to 'puddle', then for the most even finish, use a short pile gloss roller, worked well to remove excess Treadcote, to run lightly over the diamonds.

For application to Treadmaster SP (shallow textured surface) a short pile gloss roller is recommended for the best finish.

For either application method do not apply too thickly.

Wait until dry (normally 3 to 4 hours depending on conditions) before re-coating.

Do not walk on your Treadcote or allow it to come into contact with water for at least 4 hours and ideally 24 hours.

Products may vary slightly from their images. Although we have made every effort to display product colours accurately, we cannot guarantee that a device's display reflects the correct colour of our products.

+

Please choose your location for calculate shipping cost.

You may also be interested in